CYLINDER GP-TILT 1377855 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 138-7573 Link Bracket 2
B 1P-0510 Driver Group 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00602271
Illustration 2 g00602328
Use Tool (B) to install seals (8), if necessary. Ensure that the lip of the seal is toward the inside of the housing.
If the water temperature regulator is installed incorrectly, it will cause the engine to overheat.
Illustration 3 g00602198
Install four water temperature regulators (5) with the spring upward. Install gasket (6).
Illustration 4 g00602197
Use Tool (A) and a suitable lifting device to position water temperature regulator housing (4) on the engine. Install bolts (3).
Illustration 5 g00602196
Connect two tubes (2) to the water temperature regulator housing.
Illustration 6 g00624685
Install a new seal for the elbow in hose (1). Lubricate the bore of the seal with glycerin. Connect hose (1) to the water temperature regulator housing.
Fill the cooling with coolant to the correct level. See the Operation and Maintenance Manual for the correct coolant to use.