CYLINDER HEAD GP 1442966 - Caterpillar

Remove Fuel Injection Nozzle Adapters
For later fuel injection nozzles, refer to Disassembly and Assembly document, SENR3920, "Fuel Injection Nozzles and Adapters". Start By:a. remove valve coversb. remove rocker shaft assemblies and pushrodsc. remove fuel injection nozzles
Be sure that the piston is at Top Center so that the valves will be held in position when the springs are removed.
1. Remove the valve cover bases.2. Remove the valve stem locks with Tooling (A) using the following procedure: a. Install adapter plate (1) with two5/16 0S-1618 (-18 x 1 in)bolts.b. Install stud (2) and nut (3). Tighten the nut. c. Install plate (4), washer (5) and nut (6). Tighten the nut until the locks are free.d. Remove locks (7), and remove the nut, washer and plate from the stud. Remove the stud and adapter plate from the fuel injection nozzle adapter. 3. Remove rotocoil (8), spring (9) and washer (10). 4. Use Tool (B) to remove fuel injection nozzle adapter (11) from the cylinder head assembly. 5. Remove washers (12) and seals (13) from adapters (11).Install Fuel Injection Nozzle Adapters
For later fuel injection nozzles, refer to Disassembly and Assembly document, SENR3920, "Fuel Injection Nozzles and Adapters". 1. Inspect seals (3) for damage or wear, and make a replacement if necessary.2. Install washers (1) and seals (3) on adapters (2).3. Put liquid soap in the bores of the cylinder head and on the seals of the fuel injection nozzle adapters.4. Put 5P-3931 Anti-Seize Compoundon the threads of adapter (2), and install the adapters in the cylinder head assembly. 5. Use Tool (A), and tighten the adapters to a torque of 205 14 N m (150 10 lb ft). 6. Install washers (6), springs (5) and rotocoils (4). 7. Use Tool (B), and compress the springs until locks (7) can be installed. Install locks (7) on the valve stems, and remove Tool (B). For more information regarding the fuel injection nozzle adapters, see the topic "Fuel Injection Nozzle And Adapter" in Specification SENR6523.8. Install the valve cover base. Tighten the valve cover base mounting bolts to a torque of 14 3 N m (10 2 lb ft)End By:a. install fuel injection nozzlesb. install rocker shaft assemblies and push rodsc. install valve covers