CYLINDER 1453030 - Caterpillar

"Maintenance Indicator Mode"
The Engine Control Module (ECM) records data that is related to the vehicle's maintenance. If distance is selected, all maintenance indications on the service tool will be displayed in distance. Typical maintenance indications are PM 1, PM 2 and the cooling system clean/flush.If hour is selected, all maintenance indications on the service tool will be displayed in hours. Typical maintenance indications are PM 1, PM 2 and the cooling system clean/flush. The ECM provides PM 1 maintenance interval and last maintenance information.
Table 1
Alternative     Default    
"Manual Distance"
"Manual Hours"
"Automatic Distance"
"Automatic Hours"     "Off"    "PM 1 Interval"
The "PM 1 Interval" allows a maintenance interval (PM 1) to be specified by the user. This parameter ("PM 1 Interval") can be programmed only when the "Maintenance Indicator Mode" is programmed to a manual mode (distance or hours).
Table 2
Manual Distance    
Minimum     Maximum     Default    
8050 km (5000 miles)    
56325 km (35000 miles)    
24140 km (15000 miles)    
Table 3
Manual Hours    
Minimum     Maximum     Default    
100     750     300    "Engine Oil Capacity"
The "PM 1 Interval" can be determined by the ECM. The ECM bases the "PM 1 Interval" on fuel usage. This parameter ("Engine Oil Capacity") can be programmed only when the "Maintenance Indicator Mode" is programmed to an automatic mode (distance or hours). Capacity of the sump influences the maintenance interval.
Table 4
Minimum     Maximum     Default    
19 L (20 qt)    
57 L (60 qt)     Refer to Table 5.    
Table 5
Engine Model     Default    
C11 and C13    
34 L (36 qt)    
C15    
38 L (40 qt) (1)    
( 1 ) The C15 Engine with a Front Sump BrakeSaver should be programmed to 49 L (52 qt).