CYLINDER GP-HOIST 1478507 - Caterpillar

1478507 CYLINDER GP-HOIST Caterpillar parts D250D, D250E

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA1478507
147-8507
1478507

Weight: 300 pounds 136 kg.

Information:

BORE DIAMETER 101.6 mm

CLOSED LENGTH 2689 mm

PIN SIZE CAP END 50.8 mm

PIN SIZE ROD EYE 50.8 mm

ROD DIAMETER 69.85 mm

STROKE 2189

TYPE THD GLAND

Buy CYLINDER GP-HOIST 1478507 Caterpillar genuine, new aftermarket tractor parts with delivery
ARTICULATED TRUCK,

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

febi bilstein 20235 Shock Absorber, pack of one

$126.29

21 May 2022
0.2439[0.11] Pounds
LU: Amazon Global S

febi bilstein 20235 Shock Absorber, pack of one
Febi bilstein Original febi bilstein spare part - Solutions „Made in Germany" || Please use the vehicle identification at the top of the page to confirm compatibility with your vehicle. All restrictions must be observed! || Diameter of the Attachment Points: 20 mm; Piston Rod Diameter: 17 mm; Shock Absorber Type: oil pressure; Min. Length: 556 mm; Max. Length: 950 mm; Shock Absorber Bracket Type: top eye; Shock Absorber Bracket Type: bottom eye; Fitting Side: rear axle; Tube Diameter: 74 mm; Tube Diameter: 66 mm; Weight: 7,46 kg || OE numbers (for comparison purposes only): Scania 1 519 631; OEM numbers (for comparison purposes only): Koni 90-2496 || among others suitable for: Scania: 4-Serie, P, G, R, T Serie

This part in 1 request: Show. This information for suppliers only!

#1179972 1478507

2023-08-06

Number on catalog scheme: 2

Caterpillar 1478507 Parts scheme CYLINDER GP-HOIST

For full view, you need register

Compatible equipment models: 1478507:

ARTICULATED TRUCK D250D D250E Caterpillar

Information:

1. Loosen the clamp, and disconnect water line (1) from the real water spray pipe (2). 2. Remove four nuts and bolts (3), and remove the rear water spray pipe and clamps. 3. Loosen the clamp, and disconnect water line (5) from front water spray pipe (4). Remove three nuts and screws, and remove the front water spray pipe and clamps. 4. Remove two bolts (6). 5. Separate clamp (7) and O-ring seal (10) from each of the water spray pipes. Remove cap (12) and filter (8) from the clamp. Remove seal (11) and nozzle (9) from cap (12). Clean the filter and nozzle. For installation of the water spray pipes, reverse the removal steps.