CYLINDER & SEAL GP-STICK 1540734 - Caterpillar

Table 1
Parts that are Used with the 108-6170 Clamp As    
Part Number     Description     Quantity    
108-6170     Clamp As     2    
5M-2894     Hard Washer     6    
0S-1571     Bolt     2    
0S-1594     Bolt     2    
9S-8752     Full Nut     2    
6V-5066     O-Ring Seal     1    
110-0096     Ring     1    
Illustration 1 g01367077
(1) 5M-2894 Hard Washer (2) 0S-1571 Bolt (3) 8N-6406 Tube (4) 8N-8380 Elbow (5) 9S-8752 Full Nut (6) 0S-1594 Bolt (7) 6V-5066 O-Ring Seal (8) 110-0096 Ring (9) 108-6170 Clamp As
Illustration 2 g01367075
Front ViewThe clamp is adaptable to the 3500 engines that are listed above. Serial number effectivity is listed in Table 2.
Table 2
Serial Number Effectivity    
Former 8N-3639 Retainer     New 108-6170 Clamp As    
S/N:1PW00355-00449     S/N:1PW00450-UP    
S/N:23Z07408-08007     S/N:23Z08008-UP    
S/N:24Z09003-10238     S/N:24Z10239-UP    
S/N:27Z00802-00897     S/N:27Z00898-UP    
S/N:2FW00177-00411     S/N:2FW00412-UP    
S/N:49Y00298-01100     S/N:49Y01101-UP    
S/N:65Z00955-01315     S/N:65Z01316-UP    
S/N:67Z01811-02193     S/N:67Z02194-UP    
S/N:68Z01105-01321     S/N:68Z01322-UP    
S/N:95Y01089-01312     S/N:95Y01313-UP    
S/N:CBN00256-00477     S/N:CBN00478-UP    
S/N:S2Z00101-00143     S/N:S2Z00144-UP    Installation Procedure
Install O-Ring seal (7) and centering ring (8) onto coolant bypass tube (3) .
Assemble clamps (9) onto bypass tube (3) .
In order to fasten the clamps, install the following components:
Bolts (6)
Washers (1)
Nuts (5)
Tighten the bolts so that the clamps remain in place on the tube.
Align the boss of clamp (9) with the bolt holes of elbow (4) .
Install two bolts (2) and two washers (1) onto the elbow.
Tighten bolts (2) .Torque ... 47 9 N m (35 7 lb ft)
Tighten bolts (6) .Torque ... 47 9 N m (35 7 lb ft)