CYLINDER GP-TILT 1546904 - Caterpillar

(10)Engine Crankcase
1. Run engine long enough to warm oil. Park on level ground. Stop engine. Open drain valve and drain oil. 2. Remove old filter.3. Clean filter base. Make sure all of old gasket is removed. 4. Apply thin film of clean oil to gasket of new filter.5. Install filter, tighten until gasket contacts base. Tighten filter an additional 3/4 turn. Do not overtighten.6. Close drain valve. 7. Remove breather. Wash breather in clean solvent.8. Inspect seal, install new seal if necessary. Install breather. Tighten bolt.9. Fill crankcase. See REFILL CAPACITIES.10. Start engine and run at low idle to fill filter housing. Check oil level. Add oil if necessary.11. Check for leaks.(11)Transmission, Bevel Gear And Steering Clutch Compartment
1. Remove filter plug and allow oil to drain. 2. Remove cover and old elements. 3. Clean cover and inspect seal. Install new seal if necessary. 4. Secure new element to cover. Install element, cover and drain plug. 5. Remove cover, spring, screen and magnets from magnetic strainer. Wash screen in clean solvent. Clean magnets with a stiff brush, a clean cloth or pressure air. Do not drop or rap magnets. 6. Clean cover and check seal. Install new seal if necessary.7. Install magnets, screen, spring and cover.
When using pressure air, wear safety face shield and protective clothing. Use 30 PSI [2 kg/cm2] maximum pressure air for cleaning pressure.
8. Start and run engine at low idle to fill filter. Add oil to bring level to FULL mark on dipstick. 9. If tractor is equipped with a modular cab, the transmission level dipstick and filler tube are located above batteries on outside of cab.(12)Fan And Adjusting Pulley Bearings
1. Lubricate 1 fitting. 2. Lubricate 1 fitting.(13)Bulldozer Tilt Brace
Lubricate 1 fitting.(14)Bulldozer Tilt Brace Ball And Socket
Lubricate 1 fitting on each side of tractor. Total 2 fittings.(15)Bulldozer Tilt Brace (7A Only)
Lubricate 2 fittings on each side of tractor. Total 4 fittings.(16)Cable Control Shroud Bearings
Lubricate 6 fittings.(17)Cable Control Clutch Lever Rollers
Lubricate 1 fitting on each side of cable control. Total 2 fittings.(18)Cable Control Lever Shaft And Brake Lever Bearings
1. Lubricate 2 fittings. 2. Lubricate 1 fitting on each side of cable control. Total 2 fittings.(19)Parking Brake Lever
Depress brake pedals and engage parking brake lever. Release pedals. If pedals retract fully, contact your Caterpillar dealer for adjustment.Modular Cab
Depress brake pedals and engage safety lever (lever must fully engage). Release pedals. If pedals retract fully, contact your Caterpillar dealer for adjustment. Partial pedal travel is normal. However, if pedal travel becomes excessive, see Item (20).(20)Steering Clutch Brakes
Check adjustment. Adjust brakes when pedal travel reaches 5 to 5 1/2 inches (127 to 140 mm).To Adjust:
1. Remove guard and cover. 2. Turn adjusting screw in until tight (brake band tight against brake drum). Back screw out 1 1/2 turns (9 clicks).(21)Fan, Alternator And Compressor Belts
Check condition of belts. Always install a matched set of belts when any belt requires replacement.Fan Belts
1. Correct adjustment allows approximately 7/8 inch (22.1 mm) deflection at this point. 2. To adjust: Loosen mounting bolts and