CYLINDER & LINES GP-STICK 1589014 - Caterpillar

TYPE="LEVEL" DEPTH="1" @@@-->Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
B     5P-1733     Seal Locator     1    
C     5P-1737     Bolt     3    
D     9S-8858     Nut (Seal Installer)     1    
E     6V-6142     Seal Installer     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: The crankshaft front seal and the wear sleeve must be replaced at the same time. Once the crankshaft front seal and the wear sleeve are separated, these components cannot be used again.Note: Do not use any type of lubricant during the installation of the crankshaft front seal and the wear sleeve.
Illustration 1 g01042507
Fasten Tooling (B) to the crankshaft with Tooling (C) .Note: Install the crankshaft front seal with the arrow that shows the direction of crankshaft rotation toward the front of the engine.
Position wear sleeve (2) and crankshaft front seal (1) on Tooling (B). Install Tooling (E) on Tooling (B). Lubricate the face of the washer on Tooling (D). Install Tooling (D) on Tooling (B) .
Tighten Tooling (D) until Tooling (E) contacts Tooling (B) .
Remove Tooling (D), and Tooling (E) from Tooling (B) .
Remove Tooling (C) and Tooling (B) from the crankshaft.End By: Install the vibration damper and the pulley. Refer to Disassembly and Assembly, "Vibration Damper and Pulley - Remove and Install".