CYLINDER GP-BOOM 1589058 - Caterpillar

Installation Procedure
Note: Cleanliness is an important factor. Before you begin the installation procedure, the exterior of the components should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism. Precision components can be damaged by contaminants or by dirt. Keep components covered and protected at all times.Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Illustration 1 g01367625
For photographic purposes, the hydrostatic piston pump has been removed.
Position hydraulic block assembly (16) and install bolts (15). Connect tube assembly (13). Connect hose assemblies (14) and connect hose (12).
Illustration 2 g01367619
For photographic purposes, the hydrostatic piston pump has been removed.
Connect tube assembly (11). Connect hose assemblies (7) and (9). Connect harness assembly (10) and install clip (8).
Illustration 3 g01367612
For photographic purposes, the hydrostatic piston pump has been removed.
Connect hose assembly (6).
Illustration 4 g01367607
Connect tube assemblies (5) and tighten the clamps.
Illustration 5 g01367603
Install plate assembly (4) and install bolts (3).
Illustration 6 g01367600
Install floor mat (2). Install support assemblies (1).
Fill the hydraulic tank. Refer to Operation and Maintenance Manual, "Hydraulic System Oil Level - Check". End By:
Install the bottom guard. Refer to Disassembly and Assembly, "Bottom Guard - Remove and Install".