CYLINDER GP-BUCKET 1589061 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01245956
Slide locking tab (2) into the unlocked position.
Disconnect harness assembly (3) from engine oil pressure sensor (1) .
Remove engine oil pressure sensor (1) .
Remove O-ring seal (4) from engine oil pressure sensor (1) .Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     1U-6396     O-Ring Assembly Compound     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g01245956
Install a new O-ring seal (4) to the groove in engine oil pressure sensor (1). Lubricate the O-ring seal with Tooling (A) .
Install engine oil pressure sensor (1). Tighten the engine oil pressure sensor to a torque of 10 N m (89 lb in).
Connect harness assembly (3) to engine oil pressure sensor (1) .
Slide the locking tab (2) into the locked position.
Check the level of the engine oil. If necessary, fill the engine oil pan to the correct level that is indicated on the engine oil level gauge. Refer to Operation and Maintenance Manual, "Engine Oil Level - Check".