CYLINDER GP-TILT 1677996 - Caterpillar

problem is a sluggish response by the machine.The probable cause may be listed below.
The compensator was set improperly.
There is a blockage in the suction strainer.
There is a blockage in the oil filter.
There is a faulty control valve.
The setting for pump flow is low.
There is an excessive load on one or more systems.
There is a faulty pump.
The wrong type of hydraulic oil was used.
The hydraulic oil is not up to operating temperature.
There is a fault in the electrical circuit. The problem is an erratic grade control.The probable cause may be listed below.
The grade controls were set incorrectly. Refer to the Operation and Maintenance Manual for the grade control on your machine.
There is one or more run/standby switches in the standby position.
There is one or more gain adjustments turned counterclockwise to the maximum setting.
There is a fault in the electrical circuit. The problem is high hydraulic oil temperature that is above the acceptable range.The probable cause may be listed below.
The oil level in the hydraulic tank is low.
The hydraulic pressure is too low or the pressure is too high.
The oil filter is clogged.
There is a faulty bypass valve in another system.
There is a restriction of the flow of oil through the oil cooler.
There is a faulty motor in another system.
There is a restriction in an hydraulic oil line.
There is an excessive load on one or more systems.
The wrong type of hydraulic oil was used.