CYLINDER GP-STICK 1709807 - Caterpillar

1709807 CYLINDER GP-STICK Caterpillar parts 311C

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA1709807
170-9807
1709807

Weight: 246 pounds 111 kg.

Buy CYLINDER GP-STICK 1709807 Caterpillar genuine, new aftermarket tractor parts with delivery
EXCAVATOR,

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

$32.66

26 Dec 2019
1.0 Kilograms
-: -

Van Wezel 1709807 Exterior Mirrors
Outer/Inner Mirror: Complete Mirror; Convex; for electric mirror adjustment; Heatable || Paired article numbers: 1709808 || Quality Product

Number on catalog scheme: 1

Caterpillar 1709807 Parts scheme CYLINDER GP-STICK

For full view, you need register

Compatible equipment models: 1709807:

EXCAVATOR 311C Caterpillar

Information:

Removal Procedure
Start By:
Remove the exhaust sensor lines.
Contact with high pressure fuel may cause personal injury or death. Wait 60 seconds after the engine has stopped to allow fuel pressure to purge before any service or repair is performed on the engine fuel lines.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Contact with high pressure fuel may cause fluid penetration and burn hazards. High pressure fuel spray may cause a fire hazard. Failure to follow these inspection, maintenance and service instructions may cause personal injury or death.
Turn the fuel supply to the OFF position.
Disconnect the battery. Refer to Operation and Maintenance Manual, "Battery or Battery Cable - Disconnect".
Remove all components in order to access to the wiring harness.
Illustration 1 g02140798
Loosen clamp assemblies (1) and remove hose (2) .
Illustration 2 g02140852
Disconnect fittings (3) and (7) .
Remove bolts (5) , (6) , and (8) and remove tube assembly (4) .
Remove bolt (9) .
Illustration 3 g02140971
Remove nuts (10) and remove bracket (11) .
Disconnect harness assemblies (12) .
Illustration 4 g02141940
Typical Example
Illustration 5 g02141948
Illustration 6 g02156903
Position harness assembly (13) out of the way with cable straps.
Disconnect tube assembly (16) and remove fitting (15) .Note: Relief valve (14) is a two-piece valve which should not be disassembled.Note: Do not loosen at Location (X) .
Remove relief valve (14) .Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Install relief valve (14) in the reverse order of removal.
Tighten relief valve (14) to a torque of 95 3 N m (70 2 lb ft).