CYLINDER GP-BRAKE 1762570 - Caterpillar

Photo illustrations were taken on a marine engine. Procedures and tooling would be the same for any other 3300 Direct Injection Version. 1. Remove fuel injection lines from the nozzles and fuel injection pump housing.2. Remove bolt (1) and clamp (2) from the fuel injection nozzles to be removed.3. Install tool (A) with the inside lip of the puller on the lower stepped diameter of the nozzle and the tip of the button in the threaded hole for bolt (1).
Do not exceed a torque of 17 N m (150 lb.in.) on the screw in tooling (A) during removal of the nozzle. Added force can cause the stem of the nozzle to bend or break off.
4. Tighten the screw in tooling (A) to a maximum torque of 17 N m (150 lb.in.) to remove fuel injection nozzle (3).5. If the fuel injection nozzle can not be removed with a maximum torque of 17 N m (150 lb.in.) on the screw of tooling (A), remove tooling (A). 6. Remove the protective cap from fuel injection nozzle (3), and install tooling (B) as shown.
Hold tool (B) so the center line of the tool is in alignment with the centerline of fuel injection nozzle (3). This will prevent distortion of the nozzle which can cause it to bend or break off during removal.
7. Remove the fuel injection nozzle with tool (B).8. If tool (B) was used to remove the fuel injection nozzle, make a replace of the nozzle.9. If tool (A) was used to remove the fuel injection nozzle, remove the carbon dam seal on the end of the nozzle.Install Fuel Injection Nozzles
1. Use tool (A) to clean the bore for the fuel injection nozzle. Use an open end wrench or tap driver to turn tool (A).2. Make reference to Special Instruction, Form No. SEHS7292, for the use of tooling (B). Clean the fuel injection nozzle with tooling (B). 3. Install a new seal (4) on fuel injection nozzle (3).4. Put carbon dam seal (5) on the small end of tool (C), and expand it by sliding it to the large end. Put tool (C) against the fuel injection nozzle and slide carbon dam seal (5) off tool (C) on to the nozzle. Slide the carbon dam seal into position in the groove on the nozzle as shown. 5. Put fuel injection nozzle (3) in position in the cylinder head. Install clamp (2) and bolt (1) to hold the nozzle in position.6. Install the fuel injection lines on the fuel injection pump housing and fuel injection nozzles. Tighten the fuel line nuts to a torque of 40 7 N m (30 5 lb.ft.).7. Remove (bleed) the air from the fuel lines. See priming the fuel system in the maintenance guide.End By:a. install fuel injection lines