CYLINDER & SEAL GP-STICK 1772442 - Caterpillar

Reinforcement Of Support Assembly
(1) Cut off the end of beam (1) to a length of 171.5 (6.75"). Grind and clean the end of the beam. (2) Remove any weld cracks (A) along the length of beam (1) to a depth of 6.4 (0.25") with an Arcair torch. Again weld areas (C); use 6.4 (0.25") V-groove welds. (3) Tack weld plates (2), (3) and (4) in position. Weld all around plates (2), (3) and (4) with a 7.9 (0.31") weld. Use a fillet or groove weld, as needed. Check all the plates that are in the hinge area for fit before they are welded in position.(4) Tack weld plate (5) in position on the centerline of hinge plate (6). Weld along both sides of edges (D) with a 7.9 (0.31") fillet weld. (5) Tack weld plate (7) in position on the centerline of hinge plate (8). Weld along both sides of edges (E) with a 7.9 (0.31") fillet weld. Weld along both sides at (F) with a 6.4 (0.25") fillet weld.(6) Tack weld plate (9) in position and weld along both sides of plate (9) with a 7.9 (0.31") fillet weld. Tack weld plate (10) in position against plate (7) and the end of beam (1). Weld on both sides at (G) with a 12.7 (0.50") fillet weld. Weld along edge (H) to the beam with