CYLINDER AS 1850186 - Caterpillar

Illustration 1 g06307656
Typical example
Table 1
Item Qty Part Specification Description
1 1 442-1907 Cover Torque to 130 20 N m (96 15 lb ft).
2 1 6H-9691 O-Ring Seal Lubricate the seal lightly with the lubricant that is being sealed.
3 22 9D-6135 Spring Length under test force is 90.5 mm (3.56 inch).
Test force is 1535 44 N (345 10 lb).
Free length after test is 115.49 mm (4.547 inch).
4 22 9D-6093 Spring Length under test force is 90.5 mm (3.56 inch).
Test force is 4235 254 N (952 57 lb).
Free length after test is 116.50 mm (4.587 inch).
5 1 375-1155 D-Ring Seal Lubricate the seal lightly with the lubricant that is being sealed.
6 1 442-9217 Gusset Lubricate the seal lightly with the lubricant that is being sealed.
7 4 164-3261 Spring Length under test force is 100.0 mm (3.94 inch).
Test force is 1468 N (330 lb).
Free length after test is 133.0 mm (5.24 inch).
8 4 244-2306 Nut Tighten hat nuts in a crisscross pattern to 100 N m (74 lb ft).
Ensure that the piston housing is seated against the anchor.
Again tighten the bolts in a crisscross pattern to 100 N m (74 lb ft).
Again tighten the hat nuts in a crisscross pattern to 100 20 N m (74 15 lb ft).
Again tighten the bolts in a crisscross pattern to 100 20 N m (74 15 lb ft).
9 8 6V-5696 Bolt
10 1 2M-9780 O-Ring Seal Lubricate the seal lightly with the lubricant that is being sealed.
As required, use the following shims to maintain proper bearing preload.
11 1 4D-5642 Shim Pack Thickness 2.89 0.08 mm (0.114 0.003 inch).
12 1 166-8815 Final Drive Seal Seals and all contacting surfaces must be clean and dry when parts are assembled. Apply a thin coat of oil on the contact surfaces of the metal seals prior to installing. The metal seals must be assembled square with the bore. The rubber toric seals must not bulge and must not be twisted.
13 4 365-6133 Taperlock Stud Torque to 65 10 N m (48 7 lb ft).
14 1 2H-6340 O-Ring Seal Lubricate the seal lightly with the lubricant that is being sealed.
15 8 8T-0357