CYLINDER GP-TILT 1923884 - Caterpillar

Remove & Install Expansion Tank
Start By:a. remove air separators
Earlier 34081. Drain the cooling system into a suitable container for storage for storage or disposal.2. Loosen clamp (1) and remove the hose.
Earlier 34083. Loosen two clamps (2) and (3).
Earlier 34124. Remove two bolts and washers (1).
Earlier 34125. Remove two bolts and washers (3).6. Remove two clamp straps and rubber damper (2). Later expansion tank straps and rubber dampers are one piece.
Earlier 34087. Attach a strap (4) and hoist to expansion tank (5).
Earlier 34088. Remove four mounting bolts and washers (6).9. Remove expansion tank (5). The approximate weight of the expansion tank for the 3408 and 3412 Marine Engine is 29 kg (64 lb).10. The following steps are for the installation of the expansion tank.
Earlier 340811. Attach a strap (4) and hoist to expansion tank (5).
Earlier 340812. Place the expansion tank in position on the engine and install four mounting bolts and washers (6).
Earlier 341213. Place the expansion tank in position on the engine. Install two clamp straps and rubber dampers (2). Install two bolts and washers (3). Later expansion tank straps and rubber dampers are one piece.
Earlier 341214. Install two bolts and washers (1).
Earlier 340815. Install two boots and replace two clamps (2) and (3).16. Tighten clamps (2) and (3).
Earlier 340817. Install the hose and tighten clamp (1).18. Fill the cooling system with the proper amount of coolant. See the Operation & Maintenance Manual.End By:a. install air separators