CYLINDER GP 1M1580 - Caterpillar

Connect air conditioner hose assembly (31) from refrigerant accumulator (30). Connect hose (33) from water valve (32). Connect hose (29) from the air conditioner.
Illustration 6 g01184347
Connect steering hose assemblies (27) and cable strap (28) .
Illustration 7 g01183907
Connect hose assemblies (25) and (26) .
Illustration 8 g01184341
Connect hose assemblies (23). Connect test hoses (24) .
Illustration 9 g01184305
Connect harness assemblies (21) and tighten screws (22) .
Illustration 10 g01184299
Connect harness assembly (18). Connect ground strap (19) and install bolt (20) .
Illustration 11 g01184294
Connect hose assembly (16) at in-line refrigerant dryer (15). Install bolt (17) .
Illustration 12 g01186238
Illustration 13 g01184273
Install panel (13) and install bolts (14). Tighten bolts (12) .
Illustration 14 g01184220
Install bolt (11) .
Illustration 15 g01184216
Install cover (9) onto panel (10) .
Illustration 16 g01184241
Install bolts (8) that retain bracket (7) .Note: Exhaust extension (6) was installed with the cab.
Illustration 17 g01184233
Install right side radiator guard (5) and bolts (4) .
Illustration 18 g01184215
align the hole of tilt cylinder (3) with the cab and install pin (2). Install the cotter pin.Note: It may be necessary to raise the cab slightly with a suitable lifting device so that pin (2) may be installed.
Illustration 19 g01184204
Connect hose assembly (1) to the underside of the cab.
Charge the air conditioner system. Refer to Service Manual, SENR5664, "Air Conditioning and Heating Systems with R-134a Refrigerant" for the correct procedure. Refer to Special Publication, NEDG5065, "Air Conditioning Tools" for the correct tools.
Turn the battery disconnect switch to the ON position. Refer to Operation and Maintenance Manual, "Battery Disconnect Switch".