CYLINDER GP-TILT 1U0418 - Caterpillar

Type)
5N1729 Single Plate Clutch; 5N1730 Double Plate Clutch; 5N2851 Single Plate Clutch; 5N2853 Double Plate Clutch; 5N4155 Single Plate Clutch; 5N4156 Double Plate Clutch
5N1730 ShownA force (F) of 755 N (145 lb.) must be necessary to engage a SINGLE PLATE CLUTCH. The force must be at 90° to the clutch lever and 345 mm (13.6 in.) from the center of the lever shaft.A force (F) of 512 N (115 lb.) must be necessary to engage a DOUBLE PLATE CLUTCH. The force must be at 90° to the clutch lever and 541 mm (21.3 in.) from the center of the lever shaft.Torque the bolt that holds the clutch lever on the shaft to ... 100 N m (75 lb.ft.)(1) Torque for hub nut: Single plate clutch ... 40 N m (30 lb.ft.) + 60° to 90°Double plate clutch ... 40 N m (30 lb.ft.) + 120° to 150°(2) Torque for bolt that holds the lock in place ... 26 N m (21 lb.ft.)(3) End clearance for shaft ... 0.10 to 0.18 mm (.004 to .007 in.)(4) Thickness of clutch plate (new) ... 11.00 to 11.25 mm (.433 to .443 in.)(5) Torque for two bolts that hold the yoke to the shaft ... 51 N m (38 lb.ft.)(6) Torque for two bolts that hold the collar assembly together ... 40 N m (30 lb.ft.).6N7940 Clutch Group (Front)
5N1729 SINGLE PLATE CLUTCH is part of this group.(1) Torque for twelve bolts ... 135 14 N m (100 10 lb.ft.)3N7840 Single Plate Clutch; 3N7843 Double Plate Clutch
3N7843 ShownA force (F) of 555 N (125 lb.) must be necessary to engage a SINGLE PLATE CLUTCH. The force must be at 90° to the clutch lever and 345 mm (13.6 in.) from the center of the lever shaft.A force (F) of 695 N (156 lb.) must be necessary to engage a DOUBLE PLATE CLUTCH. The force must be 90° to the clutch lever and 345 mm (13.6 in.) from the center of the lever shaft.Torque the bolt that holds the clutch lever to the shaft to ... 100 N m (75 lb.ft.)(1) Torque for hub nut: Single plate clutch ... 40 N m (30 lb.ft.) + 60° to 90°Double plate clutch ... 40 N m (30 lb.ft.) + 120° to 150°(2) Torque for bolt that holds the lock in place ... 26 N m (21 lb.ft.)(3) End clearance for shaft ... 0.10 to 0.18 mm (.004 to .007 in.)(4) Thickness of clutch plate (new) ... 11.00 to 11.25 mm (.433 to .443 in.)(5) Torque for two bolts that hold the yoke to the shaft ... 51 N m (38 lb.ft.)(6) Torque for two bolts that hold the collar assembly together ... 40 N m (30 lb.ft.)3N8614 Triple Plate Clutch
Make sure the wear sleeves (A and B) are installed even with the shoulders of the shaft, radius side out. If the edges of the sleeve and shoulder