CYLINDER BLOCK AS 2021259 - Caterpillar

class="content_table content_table_30292827262524232221201918302928272625242322212019183029282726252423222120191830292827262524232221201918" BORDER="1" CELLPADDING="7" WIDTH="660" >
Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
*******Group 3*******
100% 100% 0% 0% 0% 0%
This is a 4.0-hour job for Group 3
Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
*******Group 4*******
100% 100% 0% 0% 0% 0%
This is a 4.0-hour job for Group 4
PARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
MAKE EVERY EFFORT TO COMPLETE THIS PROGRAM AS SOON AS POSSIBLE.
COPY OF OWNER NOTIFICATION FOR U.S. AND CANADIAN OWNERS
XYZ Corporation
3240 Arrow Drive
Anywhere, YZ 99999
PRIORITY - PRODUCT IMPROVEMENT PROGRAM FOR INSPECTION AND REPAIR OF ELECTRICAL WIRING ADJACENT TO FERRITE BEAD, SHRINK TUBING INSTALLATION AROUND THE BEAD AND FLASHING NEW SOFTWARE ON CERTAIN 3508B, 3512B, 3512C, 3516B HD, AND 3516C MARINE ENGINES
MODELS INVOLVED - Certain 3508B, 3512B, 3512C, 3516B HD,and 3516C Marine Engines
Dear Caterpillar Product Owner:
The wiring needs to be inspected, ferrite bead needs replaced, shrink tubing installed, and software replaced on the products listed below. The existing wiring can short out. You will not be charged for the service performed.
Contact your local Caterpillar dealer immediately to schedule this service. The dealer will advise you of the time required to complete this service.
We regret the inconvenience this may cause you, but urge you to have this service performed as soon as possible to prevent unscheduled downtime.
Please refer the dealer to their Service Letter dated 27Sep2007 when scheduling this service.
We regret the inconvenience this may cause you, but urge you to have this service performed as soon as possible to prevent unscheduled downtime.
Caterpillar Inc.
Identification #(s)
Attached to 27Sep2007 Service Letter
Rework Procedure
Ferrite Bead Rework:
1. Remove the ECM J1 connector on the