CYLINDER HEAD GP 2061564 - Caterpillar

(5) High VoltageThe warning labels for high voltage are located on the following components: the rear terminal box, the customer connection box and the circuit breaker box.
g00308803
Personal injury or death can result from high voltage.When power generation equipment must be in operation to make tests and/or adjustments, high voltage and current are present.Improper test equipment can fail and present a high voltage shock hazard to its user.Make sure the testing equipment is designed for and correctly operated for high voltage and current tests being made.When servicing or repairing electric power generation equipment:
Make sure the unit is off-line (disconnected from utility and/or other generators power service), and either locked out or tagged DO NOT OPERATE.
Make sure the generator engine is stopped.
Make sure all batteries are disconnected.
Make sure all capacitors are discharged.
(6) Automatic StartingThe warning label for high voltage is located on the rear terminal box.
g00327883
When the engine is in the AUTOMATIC mode, the engine can start at any moment. To avoid personal injury, always remain clear of the the engine when the engine is in the AUTOMATIC mode.
(7) High Voltage (Power Source)The warning label for electrical distribution (generator) is located on the rear terminal box.
g00481390
High voltage. Power source must be disconnected before working on equipment. Failure to disconnect power source could result in injury or death.
(8) BatteryThe warning label for the battery is installed on the side of the engine or in a visible location near the battery. If batteries are located on both sides of the package, the warning label is located on both sides of the package.
g00904709
Batteries give off flammable fumes which can explode.To avoid injury or death, do not strike a match, cause a spark, or smoke in the vicinity of a battery.
(9) LiftingThe warning label for lifting is located on the base near the lifting holes.
g00524148
Improper lift rigging can allow unit to tumble causing injury and damage.
1. Use an adequate spreader bar because the center of gravity is above the base lifting points.2. Attach four properly rated chains from the base lifting holes to the spreader bar.3. Adjust the chain lengths in order to position the spreader bar over the center symbol for level lift.4. Use a single point center lift arch and use a 5N-2171 Film when present.Read the Manual (10)This safety message is located on the right-hand side of the engine on top of the bracket for the electronic control module.
g01370904
Do not operate or work on this product unless you have read and understand the instructions and warnings in the OperationandMaintenanceManual. Failure to follow the instructions or heed the warnings could result in injury or death. Contact your Catdealer for replacement manuals. Proper care is your responsibility.