CYLINDER & VALVE GP-TILT 2081139 - Caterpillar

Illustration 8 g06303075
Install four torx head screws (A) and torque to 6 1 N m (53 9 lb in).G7P Ethernet Flashing
Note: If the display boots up with key off and then returns to a rest state, the display is not flashed. Proceed with following steps.Note: Use the Ethernet on the machine to flash the display. If flashing does not work, proceed to "Harness Procedure" for extra harness.
Illustration 9 g06333322
Open Cat® Electronic Technician (Cat ET) and navigate the menus to modify the preference settings.
Illustration 10 g06333323
Select the "Ethernet Direct Connection".
Illustration 11 g06333325
Select "Intel® Ethernet Connection (5) I219-LM".
Illustration 12 g06333327
Connect to "Winflash".
Illustration 13 g06333329
Save the settings.
Illustration 14 g06333330
Allow Cat® ET time to establish a connection to the display.
Illustration 15 g06333332
Open the file browser.
Illustration 16 g06333333
Navigate to the flash file.
Illustration 17 g06333335
Select "Yes" to continue.
Illustration 18 g06333338
Select "Begin Flash".Harness Procedure
Illustration 19 g06333311
Illustration 20 g06333313
Illustration 21 g06333319
Illustration 22 g06333316
Make a harness with (J1) connected to the keyswitch and power supply and (J2) connect to the four Ethernet 1 ports. (J2) will have a Cat 5 Ethernet connector at the other end of the harness. Plug into the computer.
Proceed to "G7P Ethernet Flashing" and flash the display.