CYLINDER TUBE 2092574 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     5F-4764     Pry Bar     1    Start By:
Remove the rocker shaft and the pushrods. Refer to Disassembly and Assembly, SENR9537, "Rocker Shaft and Pushrod - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00511865
Remove plug (1) from the fuel manifold.
Drain the fuel from the cylinder head assembly into a suitable container for storage or disposal.
Illustration 2 g00511868
Mark bridge assemblies (4) for reference during installation.
Loosen two nuts (3) and remove cap assembly (2) .
Remove bolt (5) and spacer assembly (6) that holds the unit injector in place.
Illustration 3 g00764868
Position Tool (A) under hold-down (8). Carefully pry unit injector (7) out of the cylinder head assembly. Remove unit injector (7) .