CYLINDER GP-STICK 2107092 - Caterpillar

System Pre-Shutdown
Illustration 1 g03429280
SMS bypass cabinet (1) Bypass switch (2) Output switch (3) Input switch (4) Upper shield (5) Lower shield (6) GSM circuit breaker
When servicing or repairing electric power generation equipment:Make sure the unit is off-line (disconnected from utility and/or other generators power service), and either locked out or tagged DO NOT OPERATE. Remove all fuses.
Illustration 2 g00863047
SIO board serial connection
Illustration 3 g00697157
The "Enter User Name" / "Password" dialog box
Connect a PC to the RS-232/RS-485 port. The port is located on the bottom back corner of the System Input/Output and Isolation Board (SIO). The SIO board is located on the lower left panel in the flywheel cabinet. Refer to Illustration 2.
Run the UPSView software by double clicking the UPSView icon on your PC desktop.
Click on the "Enter Password" menu option in order to view the "Enter User Name" / "Password" dialog box.
Enter a valid "User Name". Enter a valid "Password". Refer to Illustration 3.
Depress the "<Ctrl><X>" keys in order to bring the system to zero RPM.
The system will prompt you to confirm the option. Depress "<Y>" key.Note: This procedure is only available once during a 24 hour period.Note: A minimum of 15 minutes is required to lower the speed of the flywheel to 0 RPM.Shut Down Procedure for SMS with Bypass Cabinet
Perform a system pre-shutdown. Refer to "System Pre-Shutdown".
Illustration 4 g01260515
SMS user interface (7) Key switch (8) Soft key (Home) (9) LCD display
Turn the key switch (7) to the Bypass position. Refer to Illustration 4.
Make sure that the UPS is in bypass mode. To view the mode, press the "Home" soft key (8) that is located on the user interface panel. Observe the status line on