CYLINDER GP-EXTENDABLE STICK 2107097 - Caterpillar

Typical Illustration After clutch has been installed on engine, hit output shaft sharply on the end to relieve any preload that may result due to resistance of pilot bearing being pressed into the flywheel.(1) Bearing Adjustment: Tighten bearing retainer until there is no clearance between cup and cone. Back off retainer two or three notches and assemble lock. Strike output end of shaft to seat the inner bearing cup against the bearing retainer. Endplay must ... 0.15 to 0.25 mm (.006 to .010 in) Clutch Engagement Check (On Engine):A torque of 295 to 392 N m (214 to 291 lb ft) on the splined clutch lever shaft is required to engage the clutch.Triple Plate Clutch
2W4909
Typical Illustration After clutch has been installed on engine, hit output shaft sharply on the end to relieve any preload that may result due to resistance of pilot bearing being pressed into the flywheel.(1) Bearing Adjustment: Press pilot bearing on flush with end of shaft. Check and record engine crankshaft endplay after clutch has been assembled to engine. Hit the shaft on the end to relieve any bearing preload. Remeasure the engine crankshaft endplay. The endplay must be identical to the value recorded previously. Clutch Engagement Check (On Engine):A torque of 325 to 435 N m (238 to 320 lb ft) on the splined clutch lever shaft is required to engage the clutch.