CYLINDER GP-ADJ CAB RISER 2164205 - Caterpillar

Removal Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Drain the coolant from the engine into a suitable container for storage or for disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
Illustration 1 g02022243
Attach a suitable lifting device onto engine oil cooler (1). The weight of engine oil cooler (1) is approximately 150 kg (330 lb). Remove bolt (3) in order to disconnect clamp (4). Check coupling (2) for leaks. Note: Never overtighten the bolts in coupling (2) in order to stop a leak. Drain the tube assembly and loosen the bolts on coupling (2). Do not remove coupling (2) but pry in order to disengage the teeth in coupling (2). Remove coupling (2) from the joint.
Illustration 2 g02022246
Remove bolts (8). Disconnect tube assembly (7). Remove bolts (6). Disconnect tube assembly (5).
Illustration 3 g02022250
Remove bolts (12). Disconnect tube assembly (11). Remove bolts (10). Disconnect tube assembly (9).
Illustration 4 g02022251
Remove bolts (13) from engine oil cooler (1). Repeat for the opposite side.
Illustration 5 g02022259
Lower engine oil cooler (1) to the ground. Installation Procedure
Install engine oil cooler (1) in the reverse order of removal.
Tighten the bolts in coupling (2) to a torque of 20 1 N m (177 8 lb in).