CYLINDER BLOCK GP 2168231 - Caterpillar

Perform the following procedure to connect the wiring from the driven equipment.
Illustration 197 g01242443
Location for the customer connection inside the remote panel
Refer to Illustration 197. Make the connections for the driven equipment on the right side of the terminal strip. Table 17 lists the connections that are available.Wiring for the Emergency Stop CircuitThe circuit for the emergency stop buttons is complete when the remote panel is installed. An additional emergency stop button may be added to the circuit. Refer to Illustration 198. Remove the bridge and connect the additional button according to the Illustration.
Illustration 198 g01242557
Emergency stop circuit with an additional emergency stop buttonWiring for the Gas Shutoff ValveThe circuit for the emergency stop buttons is complete when the remote panel is installed. Refer to Illustration 198.
Illustration 199 g01256413
Circuit for the gas shutoff valveInitial Start-up of the Engine
Refer to Special Instruction, REHS2558-02, "Installation and Initial Start-Up Procedure for G3500 A3 Engines"Register the Retrofit
Because retrofits to a prime product will change the configuration of the product, updating the configuration in SIMSi and AIMS is important. If the retrofit information is not provided, Caterpillar will not be able to provide important product updates.The following information includes instructions on registering the updates and retrofits.
When performing a retrofit installation, record the vital information in Table 21. Note: If the procedure is performed by the customer, ask the customer to record the proper information.
Table 21
Repair Date        
Product Serial Number        
Service Hours or Service Meter Units        
Removed Component Part Number (1)        
Removed Component Serial Number (1)        
Installed Component Part Number (2)        
Installed Component Serial Number (3)        
( 1 ) Only applies if a component is replaced by a retrofit component. If the product is an engine, and the product retrofit is a kit for upgrading the engine, disregard the "Removed Component" information. Refer to detailed instructions in Step 3 for more information.
( 2 ) Record the highest level retrofit kit, arrangement, or group part number.
( 3 ) Most retrofits will not have a serial number. Exceptions include emissions repower engines and diesel particulate filters.
Update the product configuration by entering the information from Table 21 into SIMSi and AIMS.Note: For retrofits that have a Caterpillar serial number, the AIMS application is "JIZ111-08". For retrofits that do not have a Caterpillar serial number, the AIMS application is "JIZ111-07".
For detailed instructions on updating the product configuration, refer to Special Instruction, REHS5097, "Instructions to Register the Retrofit".