CYLINDER & MTG GP-LIFT ARM 2185899 - Caterpillar

2185899 CYLINDER & MTG GP-LIFT ARM Caterpillar parts 236B, 252B, 252B3, 267B, 268B

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA2185899
218-5899
2185899

Caterpillar 2185899 CYLINDER & MTG GP-LIFT ARM

Buy CYLINDER & MTG GP-LIFT ARM 2185899 Caterpillar genuine, new aftermarket tractor parts with delivery
MULTI TERRAIN LOADER, SKID STEER LOADER,

This part in 1 request: Show. This information for suppliers only!

#147841 2185899

2018-02-22

Compatible equipment models: 2185899:

MULTI TERRAIN LOADER 267B

SKID STEER LOADER 236B 252B 252B3 268B Caterpillar

Number on catalog scheme:

Caterpillar 2185899 Parts scheme CYLINDER & MTG GP-LIFT ARM

For full view, you need register

Information:

Probable Causes
Parameters
Driven equipment
Software
Inlet air restriction
Exhaust restriction
Turbocharger
Fuel system
Fuel injectorsRecommended Actions
Table 1
Troubleshooting Test Steps Values Results
1. Check for Incorrect Configuration Parameters
A. Connect Cat® Electronic Technician (ET) to the service tool connector.
B. Use Cat ET to verify that the correct parameters are being used.
Parameters
Result: The parameters are correct.
Proceed to Test Step 2.
Result: The parameters are not correct.
Repair: Input the correct parameters. Refer to Troubleshooting, "Configuration Parameters" for additional information.
If the problem is not resolved, proceed to Test Step 2.
2. Inspect the Driven Equipment
Driven Equipment
Result: The driven equipment is OK.
Proceed to Test Step 3.
Result: The driven equipment is NOT OK.
Repair: Repair or replace damaged driven equipment.
If the problem is not resolved, proceed to Test Step 3.
3. Ensure that the latest Flash File Software is Installed in the ECM
A. Connect Cat ET.
B. Use Cat ET to verify that the correct flash file is being used.
Flash File
Result: The latest flash file is installed.
Proceed to Test Step 4.
Result: The latest flash file is not installed.
Repair: Perform the following procedure:
1. Download the latest flash file from SIS web.
2. Install the software into the ECM.
Refer to Troubleshooting, "ECM Software - Install" for additional information.
If the problem is not resolved, proceed to Test Step 4.
4. Check for a Restriction in the Inlet Air System
A. Check the air filter restriction indicator, if equipped. Refer to the Operation