CYLINDER BLOCK GP 2337007 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Loctite 271 -
B - Loctite Superflex RTV Silicone Adhesive Sealant, Blue -
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Do not turn the crankshaft or the camshaft while the camshaft gear is removed. If the front gear group is not correctly timed during installation, interference can occur between the pistons and the valves, resulting in damage to the engine.
Illustration 1 g01239429
Thoroughly clean the mating surfaces of the plate and front housing (13).Note: The mating surfaces of the plate and the front housing must be free of oil, fuel, water, dirt, assembly compounds, and any other contaminants during assembly.
Install a new gasket (15) on the plate.Note: Trim the gasket even with the bottom of the front housing after assembly.
Apply Tooling (B) to the bottom of gasket (15) in order to fill the space at the front housing and the engine oil pan.
Install front housing (13) on the dowel pins on the cylinder block.
Install cover assembly (14).
Install bolts (12).
Install bolt (10) and nut (9).
Install nuts (11).
Position strap (8) and install bolts (7).
Illustration 2 g01097597
Position bracket (3) and install bolts (2).
Install bolts (1).
Install nut (4) on the stud.
Install bolts (5) that fasten the adapter and fuel transfer pump (6) to the plate.End By:
Install the alternator. Refer to Disassembly and Assembly, "Alternator - Remove and Install".
Install the fan drive. Refer to Disassembly and Assembly, "Fan Drive - Install".
Install the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".
Install the engine support. Refer to Disassembly and Assembly, "Engine Support (Front) - Remove and Install".
Install the crankshaft position sensor. Refer to Disassembly and Assembly, "Crankshaft Position Sensor - Remove and Install".
Install the crankshaft front seal and the wear sleeve. Refer to Disassembly and Assembly, "Crankshaft Front Seal - Install".
Install the camshaft gear. Refer to Disassembly and Assembly, "Camshaft Gear - Remove and Install".