CYLINDER & MTG GP-CARRIAGE 2352662 - Caterpillar

Rework Procedure
Refer to the disassembly and assembly manual for your machine, for additional information.
1. Remove the engine compartment sheet metal on both sides of the machine. Refer to Image1.1.1 and 1.1.2.
Image1.1.1
Image1.1.2
2. Remove the hose clips, harness strap, and bolts that maintain the radiator. Refer to Image1.2.1. Do NOT disconnect the radiator hoses.
Image1.2.1
3. Remove the finger guard. Refer to Image1.3.1.
Image1.3.1
4. Unbolt the bracket that maintains the viscous clutch wire. Refer to Image1.4.1.
Image1.4.1
5. Unbolt the deflector. Refer to Image1.5.1.
6. Unbolt and remove the viscous clutch. Refer to Image1.5.1.
Image1.5.1
7. Disassemble the bottom guard that is located under the radiator guard. Refer to Image1.6.1.
Image1.6.1
8. Remove the four bolts on each side in order to disassemble the left and right brackets. Refer to Image1.7.1.
Image1.7.1
9. Unbolt the filter support from the top shroud. Refer to Image1.8.1.
Image1.8.1
10. Remove the top and bottom shroud.
11. Unbolt the sand blast grid.
12. Remove both shroud supports on right side of the machine. Refer to Image1.9.1.
Image1.9.1
13. Remove the sand blast grid. Refer to Image1.10.1.
Image1.10.1
14. Install the new 3551011/">355-1011 Sand Blast Grid Assembly. Be careful to the sandblast grid orientation. Refer to Image1.11.1.
Image1.11.1
15. Reassemble both right shroud brackets.
16. Bolt the new 3551011/">355-1011 Sand Blast Grid Assembly on to the shroud brackets on both sides of the machine with four new 8T-4195 Bolts and four new 8T-4121 Washers. Refer to Image1.12.1.
Image1.12.1
17. Reassemble the shroud, viscous clutch with wire bracket, deflector, and the other components of the machine.
18. Be careful to reassemble finger guards, keep finger guard at maximum higher to apply the torque to have a big gap with deflector. Refer to Image1.13.1.
Image1.13.1