CYLINDER AR-DUAL TILT 2453558 - Caterpillar

Illustration 2 g01063274
Use Tooling (A) and install retaining ring (27) into coupling (26).
Illustration 3 g01063273Note: Check the O-ring seal for wear or for damage. If necessary, replace the O-ring seal.
Install coupling (26). Install O-ring seal (25).
Illustration 4 g01063254
Use Tooling (B) and install bushing (24) into hub (21). Install seal (23).
Illustration 5 g01063253
Position hub (21) and install bolts (22). Tighten bolts (22) to a torque of 304 N m (224 lb ft). Install bearing cone (20) onto hub (21).
Illustration 6 g01063251
Use Tooling (C) and install bearing cups (19). Install seal (18).
Illustration 7 g01063246
Install hub (17). Install bearing cone (16) into hub (17).
Illustration 8 g01063272Note: Check the O-ring seal for wear or for damage. If necessary, replace the O-ring seal.
Install O-ring seal (15).
Illustration 9 g01063244
Install hub (12) into ring gear (14). Install ring (13).
Illustration 10 g01063238
Position hub (12) and install bolts (11). Tighten bolts (11) to a torque of 230 N m (170 lb ft).
Illustration 11 g01063237
Install axle shaft (10).
Illustration 12 g01063215
Install washer (9).
Illustration 13 g01063214
Install planetary gear (7) and needle bearings (8).
Illustration 14 g01063213
Install locking pin (5) and washer (6).
Illustration 15 g01063212
Install washer (4) and bolt (3). Tighten bolt (3) to a torque of 79 N m (58 lb ft).
Illustration 16 g01063210
Position cover (1) and install screws (2). Tighten screws (2) to a torque of 25 N m (18 lb ft).
Repeat Step 12 through Step 16 for the remaining planetary gear assemblies.
Fill the final drives with oil. Refer to Operation and Maintenance Manual, "Final Drive Oil - Change". End By:
Install the wheel and tire. Refer to Disassembly and Assembly, "Wheel and Tire - Install".