CYLINDER AS 2511550 - Caterpillar

Connect wire harness (25) at the two electrical connections.
Illustration 8 g00557490
Illustration 9 g00557488
Install two nuts (23) and the lock washers that hold three cable assemblies (24) to battery disconnect switch (22). Tighten two nuts (24) to a torque of 8 2 N m (71 18 lb in).
Install nut (21) that holds toggle switch (20) to cover assembly (19) .
Illustration 10 g00557422
Install six bolts (18) and the washers that hold cover assembly (19) to cowling assembly (12) .
Illustration 11 g00570742
Attach Tooling (A) to hood assembly (2). Position a suitable lifting device to Tooling (A), as shown. Secure the lifting device to a hoist. Position hood assembly (2) to the cowling assembly, as shown. The weight of hood assembly (2) is 218 kg (480 lb).
Illustration 12 g00570744
Install two bolts (17), the nuts, and the washers that hold hood assembly (2) to the right hand platform.
Illustration 13 g00570743
Install two bolts (16), the nuts, and the washers that hold hood assembly (2) to the frame assembly.
Illustration 14 g00570745
Install cotter (13) and the washer that holds prop assembly (15) to bracket assembly (14) .
Illustration 15 g00570741
Install nine bolts (11) and the washers that hold hood assembly (2) to cowling assembly (12) .
Illustration 16 g00570739
Connect wire harness (10) at the electrical connection. Repeat this procedure on the remaining side.
Illustration 17 g00570738
Install four bolts (8) and the washers that hold tube assembly (9) and the rectangular seal to expansion tank assembly (3) .
Illustration 18 g00570737
Install four bolts (6) and the washers that hold tube assembly (7) and the rectangular seal to expansion tank assembly (3) .
Illustration 19 g00570736
Connect hose assembly (5) to expansion tank assembly (3). Repeat this procedure on the remaining side of expansion tank assembly (3) .
Illustration 20 g00570735
Position cover (4), as shown. Install three bolts (1) and the washers that hold cover (4) to cowling assembly (2) and expansion tank assembly (3). Repeat this procedure on the remaining side of expansion tank assembly (2) .
Refill the radiator with coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change".
Refer to Operation and Maintenance Manual, "Lubricant Visconsities and Refill Capacities" for the correct refill capacities.End By:
Install the ambient air temperature sensor. Refer to Disassembly and Assembly, "Temperature Sensor (Ambient Air) - Remove and Install".
Remove the truck body retaining cable. Refer to Disassembly and Assembly, "Truck Body Retaining Cable - Remove and Install".
Remove the wheel chocks. Refer to Disassembly and Assembly, "Wheel Chocks - Remove and Install".