CYLINDER AS 2532125 - Caterpillar

Air Conditioner Control (19A If Equipped)
Illustration 6 g03366674
Air Conditioner Control - Press the top of the switch in order to activate the air conditioner. Press the switch to middle position to activate heater.Heater Control (19B If Equipped)
Illustration 7 g03366689
Heater Control - Press the top of the switch in order to activate the heater.Temperature Control (If Equipped)(20)
Temperature Control - Turn the knob to the right toCOOL. Turn the knob to the left to WARM.Heater Control (20B If Equipped)
Heater Control - Turn knob to the right to increase heat. Turn knob to the left to decrease heat.Roading Lights (21)
Roading Lights - Press the left side of the switch to the right position in order to activate the position lights and the instrument panel lights. Press the switch all the way to the left in order to turn off the roading lights.Front Work Lights and Rear Work Lights (If Equipped) (22)
Front Work Lights and Rear Work Lights - Press the left side of the switch to the middle position in order to turn on the front work lights. Press the switch all the way to the left in order to turn on the front work lights and the rear work lights. If switch is turned on more than 1 minute before key off, work lights will continue ON for 30 seconds.Hazard Flashers (23)
Hazard Flashers - Pressing the left side of the switch will cause the turn signal lights to flash continuously.Work Tool Control (If Equipped) (24)
Work Tool Control (If Equipped) - The work tool Control is designed to make using work tools easier. The system integrates quick coupler usage with work tool selection.This control provides hydraulic oil flow to the auxiliary hydraulic connections on the loader arm.12V Socket (25)
Power Receptacle (12 volt) - A 12V socket supplies power equipment and is located left side steering column.Steering Column Tilt Control (26)
Steering Column Tilt Control - Pull up on the lever in order to move the steering column to the desired position Recirculation Knob (27 If Equipped)
Recirculation Knob - Turn knob to the left for outside air flow. Turn knob to the right for in cab recirculating air flow.Operator Information
To prevent injury, make sure that no people are working on the machine or near the machine. To prevent injury, keep the machine under control at all times.Reduce engine speed when you maneuver in tight quarters or when you are going over a hill.Select the necessary travel speed before you start downgrade. Do not change travel speed while you are going downhill.When you go downgrade, use the same speed to go upgrade.Do not allow the engine to overspeed when you go downhill. Use the service brake to reduce engine overspeed when you go downhill.When the load will be pushing the machine, put the speed control in SLOW speed before you start downhill.
Adjust the operator seat.
Fasten the seat belt.
Raise the work tools in order to negotiate any obstacles.
Push down on the service brake in order to prevent the machine from moving.
Release the parking brake.
Push the direction control