CYLINDER HEAD GP 2768135 - Caterpillar

Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Ensure that all components of the camshaft are clean and free from damage. Replace any components of the camshaft that are worn or damaged.
Lubricate the bearings of the camshaft with clean engine oil. Carefully install the camshaft assembly to the cylinder block. Note: Ensure that the lobes of the camshaft and the camshaft bearings are not damaged.
Illustration 1 g03813990
Camshaft gear removed for clarity.
Illustration 2 g03813987
Typical example
Position camshaft retainer (3) to the front housing. Ensure that the holes in the camshaft retainer are aligned with the holes in the front housing. Install bolts (7) and tighten the bolts to a torque of 11 N m (97 lb in).
Ensure that timing Marks (X) are aligned with crankshaft gear (4), camshaft gear (1), and idler gear (5). Ensure that the mesh of the gears is correct.
Install oil pump cover (6). Refer to Disassembly and Assembly, "Engine Oil Pump - Install" for the correct procedure. End By:
Install the lifters. Refer to Disassembly and Assembly, "Lifter Group - Remove and Install" for the correct procedure.
Install the fuel injection pump gear. Refer to Disassembly and Assembly, "Fuel Injection Pump Gear - Install" for the correct procedure.
Install the front housing. Refer to Disassembly and Assembly, "Housing (Front) - Install" for the correct procedure.