CYLINDER & SEAL GP-HYDRAULIC 2798709 - Caterpillar

Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00581044
Install two guide bolts (4) into the cylinder head, as shown. The guide bolts are used to keep gasket (3) and air inlet manifold (2) in position on the cylinder head during installation.
Put gasket (3) in position on the engine.
Illustration 2 g00580923
Put air inlet manifold (2) in position on the engine.
Install six of the eight bolts (1) and remove two guide bolts (4). Install the remaining two bolts (1) .
Tighten bolts (1) to a torque of 22 N m (16 lb ft).End By: Install the fuel injection lines. Refer to Disassembly and Assembly, "Fuel Injection Lines - Remove and Install".