CYLINDER BLOCK GP-SHORT 2822885 - Caterpillar

VIEW A- A Put lubricant on the lips of all seals.(1) Torque for upper cap bolts in lower hitch: Step 1: Install four bolts (90° apart) in cap with no shims under cap. Tighten all bolts the same amount in the sequence shown. Tighten all bolts again to ... 88 7 N m (65 5 lb.ft.)Step 2: Make sure lower cap is against frame. Measure clearance between upper cap and frame at each bolt.Step 3: Install shims under the upper cap of minimum clearance measured.Step 4: Install all bolts. Tighten bolts to final torque of ... 100 15 N m (75 10 lb.ft.)(2) Torque for bolts in lower plate on lower plate on lower hitch ... 100 15 N m (75 10 lb.ft.)(3) Torque for bolts in lower hitch pin: Step 1: Install plate without shims. Install two bolts 180° apart. Tighten bolts to ... 135 15 N m (100 10 lb.ft.)Step 2: Measure clearance 360° around plate (between plate and frame).Step 3: Install shims same thickness as minimum clearance measured minus ... 0.25 mm (.010 in.)Step 4: With correct thickness shims, install all bolts and tighten to a final torque of ... 200 25 N m (150 20 lb.ft.).(4) Before installing the bearing, lower the temperature of the bearing to ... -57° to -67°C (-71° to -89°F)(5) Torque for cover bolts in upper hitch: Step 1: Install four cover bolts and tighten two bolts 180° apart the same amount.Step 2: Tighten other two bolts the same amount.Step 3: Do above procedure again until all bolts are tightened to ... 68 34 N m (50 25 lb.ft.)