CYLINDER HEAD AS 2893210 - Caterpillar

2893210 CYLINDER HEAD AS Caterpillar parts C13

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA2893210
289-3210
2893210

Buy CYLINDER HEAD AS 2893210 Caterpillar genuine, new aftermarket tractor parts with delivery
TRUCK ENGINE,

Compatible equipment models: 2893210:

TRUCK ENGINE C13 Caterpillar

Number on catalog scheme: 12

Caterpillar 2893210 Parts scheme CYLINDER HEAD AS

For full view, you need register

Information:

Illustration 1 g03087776
This diagnostic code is recorded when the ECM reads the signal from the engine speed sensor as being incorrect. The signal that is being received by the ECM is changing at a faster rate or a slower rate than the ECM expected. The rate of change is outside the expected limits. However, this value is not outside the maximum value or the minimum value.The possible causes of this diagnostic code are listed:
The sensor has failed.
An intermittent open in the circuit.
An intermittent short in the circuit.
The ECM has failed. This is unlikely.Note: Ensure that CID 0190 FMI 10 is active. The following procedure can cause new diagnostic codes to be recorded. Ignore these created diagnostic codes. When the procedure is completed, clear the created diagnostic codes.Test Step 1. CHECK THE RESISTANCE OF THE SENSOR
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness from the engine speed sensor.
Measure the resistance between the two contacts of the connector for the speed sensor. Expected Result:The resistance measurement should be approximately 142 ohms. Results:
OK