CYLINDER & LINES GP-BUCKET 2897697 - Caterpillar

Illustration 1 g00386923
Position Sensor (Lift Lever) SchematicThis fault is recorded when the ECM determines that the lift lever position sensor signal is out of calibration. The lift lever position sensor is a PWM type of sensor. The lift lever position sensor signal wire H710-PK connects to connector contact J2-4 of the ECM. Service Notes: Ensure that the CID 0352 FMI 13 fault is on hold and that the fault present indicator is ON.An FMI 13 fault is recorded when the ECM reads the lever sensor in the neutral position, and the ECM determines that the value is not valid.Lever position sensors are automatically calibrated and the FMI 13 fault can also occur during the KEY ON calibration procedure. The levers must be in the HOLD position when the key start switch is turned to the ON position.