CYLINDER BLOCK COVER GROUP 2P6254 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Start By:
Remove the high-pressure turbocharger. Refer to Disassembly and Assembly, "Turbocharger - Remove".
Remove the precooler. Refer to Disassembly and Assembly, "Precooler - Remove".
Remove the low-pressure turbocharger. Refer to Disassembly and Assembly, "Turbocharger - Remove".
Illustration 1 g06199242
Remove the lower bracket for the precooler, the upper bracket for the precooler, and the middle bracket for the precooler.
Remove bracket (1).
Illustration 2 g06199244
Remove locknuts (2) and the spacers. Remove exhaust manifold (3) and the gaskets.
Illustration 3 g06199252
If necessary remove studs (4).Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Loctite MR2000 -
B - Loctite C5-A -
- Loctite 8008(1) -
(1) For use in EAME only
Illustration 4 g06199252
Install studs (4). Tighten studs (4) to a torque of 35 5 N m (26 4 lb ft)
Illustration 5 g06199259
Apply Tooling (A) at locations (X) and assembly exhaust manifold (3).
Illustration 6 g06199244
Illustration 7 g01866113
Typical Example
Note: Discard the nuts after use. Use new nuts for installation.
Install new gaskets with tabs facing down. Install exhaust manifold (3) and nuts (2). Tighten nuts (2) to a torque of 55 10 N m (41 7 lb ft) in the sequence shown.
Illustration 8 g06199242
Install bracket (1).
Install the lower bracket for the precooler, the upper bracket for the precooler, and the middle bracket for the precooler.End By:
Install the low-pressure turbocharger. Refer to Disassembly and Assembly, "Turbocharger - Install".
Install the precooler. Refer to Disassembly and Assembly, "Precooler - Install".
Install the high-pressure turbocharger. Refer to Disassembly and Assembly, "Turbocharger - Install".