AVSPARE.COM
parts catalog

CYLINDER HEAD AS 3124207 - Caterpillar


3124207 CYLINDER HEAD AS Caterpillar parts C-9, C9
Rating:
13
Alternative (cross code) number:
CA3124207
312-4207
3124207
Caterpillar 3124207 CYLINDER HEAD AS

Buy CYLINDER HEAD AS 3124207 Caterpillar genuine, new aftermarket tractor parts with delivery
MARINE ENGINE, TRUCK ENGINE,

You can buy:

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below
$2,398.00

28 May 2024

CN: HOMISIA
Bare Cylinder Head 312-4207 for Caterpillar CAT Engine C9 C-9
HOMISIA Part number: CA3124207, 312-4207, 3124207 || ​​​​​​​Application:for Caterpillar CAT Engine C9 C-9
$2,398.00
 

11 May 2024

CN: ZhuhaiCity Chon
EPISTA Bare Cylinder Head 312-4207 for Caterpillar CAT Engine C9 C-9
EPISTA Part number:CA3124207, 312-4207, 3124207 || ​​​​​​​Application:for Caterpillar CAT Engine C9 C-9
$2,398.00
 

23 Apr 2024

CN: ZhuhaiCity Chon
Bare Cylinder Head 312-4207 for Caterpillar CAT Engine C9 C-9
EPISTA Part number:CA3124207, 312-4207, 3124207 || ​​​​​​​Application:for Caterpillar CAT Engine C9 C-9
Number on catalog scheme: 11
  For full view, you need register

Compatible equipment models: 3124207:

MARINE ENGINE  C9  
TRUCK ENGINE  C-9   C9   Caterpillar

Information:


Illustration 1 g01676399
(1) Filler cap
(2) Engine oil level gauge (dipstick)
Remove filler cap (1) in order to ensure that the crankcase pressure is equal to the atmospheric pressure. Excess pressure or a slight vacuum will affect engine oil level that is measured.
Ensure that engine oil level gauge (2) is seated.
Illustration 2 g00735162
(3) "ENGINE STOPPED WITH OIL COLD" side
(4) "ENGINE AT LOW IDLE WITH WARM OIL" side
(5) "ADD" mark
(6) "FULL" mark
If the engine is stopped, remove the engine oil level gauge. Observe the engine oil level on "ENGINE STOPPED WITH OIL COLD" side (3).
If the engine is operating, reduce the engine speed to low idle. Remove the engine oil level gauge and observe the engine oil level on "ENGINE AT LOW IDLE WITH WARM OIL" side (4). The engine oil level should be between "ADD" mark (5) and "FULL" mark (6).
Engine damage can occur if the crankcase is filled above the "FULL" mark on the oil level gauge (dipstick).An overfull crankcase can cause the crankshaft to dip into the oil. This will reduce the power that is developed and also force air bubbles into the oil. These bubbles (foam) can cause the following problems: reduction of the oil's ability to lubricate, reduction of oil pressure, inadequate cooling, oil blowing out of the crankcase breathers and excessive oil consumption.Excessive oil consumption will cause deposits to form on the pistons and in the combustion chamber. Deposits in the combustion chamber lead to the following problems: guttering of the valves, packing of carbon under the piston rings and wear of the cylinder liner.If the oil level is above the "FULL" mark on the oil level gauge, drain some of the oil immediately.
Illustration 3 g01829113
If necessary, add engine oil. The oil filler (1) is located on the right side of the engine. For the correct engine oil to use, refer to this Operation and Maintenance Manual, "Refill Capacities and Recommendations" topic (Maintenance Section). Do not fill the crankcase above the "FULL" mark on the engine oil level gauge. Clean the filler cap. Install the filler cap.
Record the amount of engine oil that is added. For the next engine oil sample and analysis, include the total amount of engine oil that has been added since the previous oil change. This will help to provide the most accurate analysis.

Caterpillar parts catalog:

Caterpillar parts catalog
C9 Truck Engine 9DG00001-UP
C9 Marine Engine CSN00001-UP
C9 Military Vehicle Engine CKP00001-UP
C9 Urban Transit Bus Engine MTB00001-UP


Parts cylinder Caterpillar catalog:

2049539 CYLINDER BLOCK GP
330C, 330C FM, 330C L, 330C MH, 330D L, 336D LN, 627G, 637G, 973D, C-9, C9, D6R II, MTC735
3323619 CYLINDER HEAD AS
140M, 140M 2, 160M, 160M 2, 2290, 2390, 2391, 2491, 2590, 330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 340D L, 340D2 L, 511, 521, 521B, 522, 522B, 532, 541, 541 2, 5...
2012180 CYLINDER HEAD AS
330C L, C-9, C9, MTC735
1613405 CYLINDER HEAD GP
330C L, C-9, C9, MTC735
2201951 CYLINDER BLOCK GP
2290, 2390, 2391, 2491, 2590, 511, 521, 521B, 522, 522B, 532, 541, 541 2, 551, 552, 552 2, C9, CX31-C9I, TH31-E61, TK711, TK721, TK722, TK732, TK741, TK751, TK752
2049538 CYLINDER BLOCK AS
330C, 330C FM, 330C L, 330C MH, 330D L, 336D LN, 627G, 637G, 973D, C-9, C9, D6R II, MTC735
2963235 CYLINDER GP-HYDRAULIC
M318C, M318C MH, M318D, M318D MH
3501421 CYLINDER BLOCK AS
G3520B, G3520C, G3520E
9U8610 CYLINDER AR
D7H, D7R, D7R II
1350218 CYLINDER GP-HYDRAULIC
8 FT, 8-16B, AP-655C, AS3251C
3588460 CYLINDER & SEAL GP-STICK
345C, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, 349E L, 349E L VG, 349F L
9T2395 CYLINDER GP-STEERING
120G, 120H, 120H ES, 120H NA, 12G, 12H, 12H ES, 12H NA, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 143H, 160G, 160H, 160H ES, 160H NA, 163H NA
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.