CYLINDER GP-BUCKET 3154449 - Caterpillar

2. Remove bolt and clip (3). Remove sensing line (5) for water temperature gauge. Remove bolt and clip (2). Remove ammeter gauge wire (1). Remove bolts (4).3. Remove fuel injection lines. Put caps on lines and pump openings. Disconnect turbocharger oil supply and drain lines. 4. Remove cylinder head bolts (6). 5. Fasten a hoist to the cylinder head and remove it from the cylinder block. Weight of the assembly is 360 lb. (163 kg).Install Cylinder Head (D330C, D333C, 3304 & 3306 Industrial Engines)
1. Clean sealing surfaces of the cylinder head and block. Install a new gasket on the cylinder block and install the cylinder head.2. Install the rocker shaft assembly and push rods.
SIX CYLINDER ENGINES
FOUR CYLINDER ENGINES3. Put 9M3710 Anti-Seize Compound on threads of the cylinder head bolts. Install the bolts and washers and tighten the bolts in the following sequence: 1 - Tighten all bolts with numbers in order to 115 lb.ft. (15.9 mkg).2 - Tighten all bolts with numbers again in order to a torque of 175 5 lb.ft. (24.2 0.7 mkg).3 - Last, tighten all bolts (hand torque only) with numbers again in order to a torque of 175 5 lb.ft. (24.2 0.7 mkg).4 - Tighten all bolts with letters in order to a torque of 22 lb.ft. (3.0 mkg).5 - Tighten all bolts with letters again in order to a torque of 32 5 lb.ft. (4.4 0.7 mkg).6 - Last, tighten all bolts (hand torque only) with letters again in order to a torque of 32 5 lb.ft. (4.4 0.7 mkg).4. Make an adjustment of the inlet valves to get a clearance of .015 (0.38 mm) and exhaust valves to get a clearance of .025 in. (0.64 mm).5. Connect turbocharger oil supply and drain lines. Remove caps from fuel injection lines and pump openings. Install fuel injection lines. Tighten nuts to a torque of 30 5 lb.ft. (4.1 0.7 mkg).6. Install bolt and clip that hold ammeter gauge wire. Install bolt and clip that hold water temperature sensing line.7. Install oil pressure gauge line.end by:a) install valve coverRemove Cylinder Head (D330C, D333C, 3304 & 3306 Marine Engines)
start by:a) remove expansion tank and heat exchangerb) remove valve coverc) remove rocker shaft assembly and push rods 1. Remove bolts (1) that hold turbocharger oil supply line.2. Remove bolts (6) that hold turbocharger oil drain line.3. Remove bolts (4) and nuts and remove shield (2).4. Remove turbocharger oil supply line (3) and oil drain line (5). 5. Remove bolts (7) that hold elbow (8) to cylinder head. Loosen clamp (9) and remove elbow (8). 6. Disconnect the sensing line (11) for the fuel ratio control.7. Remove the fuel injection lines (10) and put covers on all fuel openings. 8. Remove the lifting eye (12) from the rear of the engine.9. Remove the remainder of the bolts that hold the cylinder head to the cylinder block.10. Install one 3/8"-16 NC forged eyebolt and fasten a hoist and