CYLINDER BLOCK GP 3228394 - Caterpillar

Removal Procedure
Disconnect batteries before performance of any service work.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00810871
Disconnect electrical connections (2) to the alternator (1) before proceeding. Mark the connections or identify the connections for later installation.
Illustration 2 g00810870
Loosen bolt (4) and bolt (5) .
Slide alternator (1) toward the engine.
Remove alternator V-belt (3) from the alternator pulley.
Remove bolts (4) and (5) .
Remove alternator (1) from the engine.Installation Procedure
Illustration 3 g00810870
Put alternator (1) in position on the engine.
Install bolts (4) and (5). Tighten bolts (4) and (5) finger tight.Note: When you install the alternator, ensure that the alternator pulley is in alignment with the crankshaft pulley within 2.4 mm (0.09 inch).
Install alternator V-belt (3) .
Slide alternator (1) away from the engine in order to tension alternator V-belt (3). For more information on the tension for the alternator V-belt, refer to the Testing and Adjusting Module, "Belt Tension Chart".
Tighten bolt (4) to a torque of 12 N m (9 lb ft).
Tighten bolt (5) to a torque of 24 N m (18 lb ft).
Illustration 4 g00810871
Reconnect electrical connections (2) to the alternator (1) before you operate the engine.