AVSPARE.COM
parts catalog

CYLINDER AS 3236671 - Caterpillar



3236671 CYLINDER AS Caterpillar parts CYLINDER
Rating:
11
Alternative (cross code) number:
CA3236671
323-6671
3236671
Caterpillar 3236671 CYLINDER AS
Weight: 29 pounds 13 kg.

Buy CYLINDER AS 3236671 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Start By:
Remove the stick.
When you are using hydraulic cylinders and puller studs, always ensure that the rated capacity of the puller stud meets or exceeds the rated capacity of the hydraulic cylinder. If the puller stud does not meet or exceed the rated capacity of the hydraulic cylinder, a sudden failure of the puller stud could occur. The sudden failure of the puller stud could result in personal injury or death.
Note: For the removal of the sleeve bearings from the stick at the pin joint for the bucket control linkage, refer to Disassembly and Assembly, "Bucket Linkage Bearings and Seals - Remove".
Illustration 1 g00592359
Remove lip seal (1).
Illustration 2 g00592391
Use Tooling (A) to remove the sleeve bearing.
Repeat Steps 1 and 2 to remove the lip seal and the sleeve bearing from the opposite side of the stick.
Illustration 3 g00604131
Remove lip seal (2) from the bore for the stick to bucket pin.
Illustration 4 g01302540
Use Tooling (A) to remove the sleeve bearing.
Repeat Steps 4 and 5 to remove the lip seal and the sleeve bearing from the opposite side of the stick.Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
B - Molybdenum Grease -
C 1P-0520 Driver Gp 1 Note: Make sure that the bearing bores for the sleeve bearings are free of paint and grease prior to the installation of the sleeve bearings.
Lower the temperature of the new sleeve bearing for the heel end of the stick.
Insert the new sleeve bearing into the stick at the connection of the stick and the heel.
Illustration 5 g02728379
(D) 9.5 0.8 mm (0.374 0.032 inch)
Use Tooling (C) to drive the new sleeve bearing into the bearing bore in the stick. Drive the new sleeve bearing into the bearing bore to the depth of Dimension (D).
Illustration 6 g02728393
Use Tooling (C) to install lip seal (1) in the outside of the sleeve bearing. Install lip seal (1) so that the lip faces outward. Drive the seal until the seal contacts the sleeve bearing. Apply Tooling (B) to the sealing lip of lip seal (1) and to the sleeve bearings.
Repeat Step 1 through Step 4 for installation of the sleeve bearing and


Parts cylinder Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.