CYLINDER AS-HYDRAULIC 3284266 - Caterpillar

Table 8
Diagnostic Codes for the Desired Speed Signal    
563-11     Loss of Desired Speed Signal    
564-02     Noisy Desired Speed Signal    
565-11     Shutdown Imminent Due to MIssing Desired Speed Signal    Expected Result:There are no diagnostic codes for the desired speed signal.Results:
No codes - There are no diagnostic codes for the desired speed signal. The problem appears to be resolved.Repair: If the engine is operating correctly at this time, the original code may have been caused by an intermittent problem in a harness or in a connector. Refer to Troubleshooting, "Inspecting Electrical Connectors", if necessary.STOP
Activated code - There is a code for the desired speed input. The circuit for the remote input for the desired speed is causing the code to be activated.Repair: Carefully inspect the J6/P6 connectors on the remote control panel. Verify that the components are in good condition.Repair the circuit for the remote input for the desired speed. Verify that the original problem is resolved.STOPTest Step 10. Check the Wiring Between the Remote Speed Control and the ECM for an Open Circuit.
Remove the electrical power from the engine.
Disconnect the P1 connector.
Disconnect the "M731-RD" wire from the "OUT" terminal on the remote speed control.
Measure the resistance between the end of the "M731-RD" wire and terminal P1-18.Expected Result:The resistance measurement is less than 5