CYLINDER HEAD GP 3356217 - Caterpillar

Illustration 56 g01887210
Put the shaft assembly on suitable blocks, as shown. Use two people to remove carrier assembly (113) from the shaft assembly. The weight of carrier assembly (113) is approximately 32 kg (70 lb).
Illustration 57 g01887212
Put the carrier assembly on a suitable block, as shown. Use a screwdriver to compress the retainer ring. Remove gear (114) from the carrier assembly. Remove retaining ring (115).
Illustration 58 g01887213
Remove spiral lockring (116). Use Tooling (G) to remove bearing (117) from the carrier. Remove seal rings (118).
Illustration 59 g01887215
Use a hammer and a punch to push spring pin (119) from the carrier assembly.
Illustration 60 g01887216
Remove shaft (128), thrust discs (120), (123), (124) and (127), and gears (122) and (126). Remove bearings (121) and (125) from the gears. Remove pin (119) from shaft (128).
Repeat Steps 87 and 88 for the remaining gears.
Illustration 61 g01887217
Remove gear (129) from the shaft assembly.
Remove seals (130) and (131) from the seal carrier.
Illustration 62 g01887218
Remove spiral lockring (132) from the shaft assembly.
Illustration 63 g01887219
Put shaft assembly on suitable blocks, as shown. Use a soft hammer to strike shaft assembly (134) until the bearing is removed from shaft assembly (133).
Illustration 64 g01889333
Remove retaining ring (135) from the shaft assembly. Remove bearing (136).
Illustration 65 g01887221
Use Tooling (H) and a suitable press to remove seal carrier (137) from the shaft assembly.
Illustration 66 g01887222
Use Tooling (L) to remove bearing (138) from the shaft assembly.
Illustration 67 g01887223
Remove gear (139) from the clutch housing.
Remove piston (140) from the clutch housing.
Illustration 68 g01887224
Remove seals (141) and (142) from the piston.
Illustration 69 g01887226
Remove spiral lockring (143). Use Tooling (G) to remove bearing (144) from the housing.