CYLINDER BLOCK GP 3483283 - Caterpillar

2 Put wear sleeve (14) with seal (13) on locator (2). Put 6V2087 Installer (5) and 9S8858 Nut (7) on locator (2) as shown. Put lubricant at location (C) [between face of washer on nut (7) and its contact area on installer (5)]. Tighten nut (7) until installer (5) is against locator (2).5.4" (137) Bore, 6 Cylinder Engines
A Tools needed: 1-9S8870 Locator, 2-5P7294 Installer, 3-5P7295 Installer, 4-9S8876 Locator, 5-9S8858 Nut, 6-618718 Bolts (three), 7-2P2346 Bolts (three), 9S8889 Bolts (two - not shown).B Install Rear Seal 1 For standard engines, fasten 9S8870 Locator (1) to the rear of the crankshaft with three 618718 Bolts (6). [Bolts (6) will go through locator (1) and gear (8), then into the crankshaft.] For engines that have a BrakeSaver, use three 2P2346 Bolts (9) to fasten locator (1) in position against sleeve (10). [On these engines the bolts will go through locator (1), BrakeSaver Rotor Assembly (11) and then into the crankshaft]. Put clean engine oil on the outside diameter (A) of gear (8) or on the outside diameter (B) of sleeve (10) on engines that have a BrakeSaver. 2 For engines that use a 9N3131 Seal (12) and 9N3134 Wear Sleeve (13), fasten 9S8870 Locator (1) to the rear of the crankshaft with three 618718 Bolts (6). [Bolts (6) will go through locator (1) and gear (8), then into the crankshaft]. Put clean engine oil on the seal lip of seal (12)