CYLINDER GP-HYDRAULIC 3539375 - Caterpillar

Illustration 1 g00506568
Transmission Upshift Switch SchematicThe transmission upshift switch has two inputs to the power train electronic control module (ECM). These inputs are normally open (N/O) and normally closed (N/C). During normal operation, one of the inputs is open and the other input is grounded. If both inputs are the same, the power train ECM detects a fault. CID 0622 FMI 03 service code is detected when both inputs are either open or shorted to the +battery. Before performing this procedure refer to table 1 in order to determine the connector and the contact that corresponds to the faulty circuit.
Table 1
Upshift Switch Status    
Switch Position    F785-WH
Circuit
N/O
J1-23    F783-GN
Circuit
N/C
J1-19    
Sw. Depressed     Closed     Open    
Sw. Released     Open     Closed    Note: Ensure that the desired fault CID 0622 FMI 03 is active.Note: The following procedure can create other faults that the power train ECM detects. Ignore these created faults and clear the created faults when CID 0622 FMI 03 is corrected.
Check for an open circuit.
Turn the disconnect switch and the key start switch to the OFF position.
Disconnect the machine harness connector J1 from the power train ECM.
At the machine harness connector for the power train ECM, check the continuity to ground of the N/C contact and the N/O contact with the transmission upshift switch activated and not activated. Refer to table 1 for the correct transmission upshift switch status.Expected Result: The continuity check does not agree with table 1.Results:
YES - The continuity check does NOT agree with table 1. The harness or the transmission upshift switch is faulty. Proceed to Step 2.
NO - The continuity check agrees with table 1. Proceed to Step 3.
Check the transmission upshift switch.
Disconnect the machine harness from the transmission upshift switch.
Check the continuity to ground of the N/C contact and the N/O contact with the transmission upshift switch activated and not activated. Refer to table 1 for the correct transmission upshift switch status.Expected Result: The continuity check does not agree with table 1.Results:
YES - The continuity check does not agree with table 1. The transmission upshift switch is faulty. Repair the switch or replace the switch. STOP.
NO - Continuity check agrees with table 1. Repair the machine harness or replace the machine harness. STOP.
Check for a short to the +battery.
At the machine harness connector for the power train ECM, check the continuity from each of the switch contact wires to the contacts J1-1, J1-6, J1-40 and J2-12.Expected Result: Continuity exists between one of the sources of the battery voltage and the switch circuit.Results:
YES - Continuity exists between one of the sources of battery voltage. The machine harness is faulty. Repair the machine harness or replace the machine harness. STOP.
NO - Continuity does not exist between one of the sources of battery voltage and the switch circuit. The machine harness is correct. It is unlikely that an power train ECM is faulty. Exit this procedure and perform CID 0622 FMI 03. If the cause is not found, replace the power