CYLINDER GP-STICK 3574703 - Caterpillar

HEIGHT="20">8C6433 SCREW-PAN HEAD
4 8C9660 WASHER
4 8T0337 SCREW-MACHINE
8 9X8256 WASHER
1 1290308 POTENTIOMETER
1 1541757 PANEL
1 1610797 CONTROL AS
1 2018021 HARNESS AS
ACTION REQUIRED
See attached Rework Procedure.
OWNER NOTIFICATION
U.S. and Canadian owners will receive the attached Owner Notification.
SERVICE CLAIM ALLOWANCES
Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
100% 100% 0% 0% 0% 0%
This is a 3.0-hour job
PARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
MAKE EVERY EFFORT TO COMPLETE THIS PROGRAM AS SOON AS POSSIBLE.
COPY OF OWNER NOTIFICATION FOR U.S. AND CANADIAN OWNERS
XYZ Corporation
3240 Arrow Drive
Anywhere, YZ 99999
PRIORITY - PRODUCT IMPROVEMENT PROGRAM FOR INSTALLING LOAD SHARING MODULE ON CERTAIN 3412 GENSETS
MODELS INVOLVED - Certain 3412 Gensets
Dear Caterpillar Product Owner:
The Load Sharing Module needs to be installed on products listed below. These units where shipped without the Load Sharing Module installed. You will not be charged for the service performed.
Contact your local Caterpillar dealer immediately to schedule this service. The dealer will advise you of the time required to complete this service.
Please refer the dealer to their Service Letter dated 07Jun2007 when scheduling this service.
We regret the inconvenience this may cause you, but urge you to have this service performed as soon as possible to prevent unscheduled downtime.
Caterpillar Inc.
Identification #(s)
Attached to 07Jun2007 Service Letter
Rework Procedure
Instructions
1. Reference.
SEBU7125 Operation & Maintenance Manual 3412 Generator
RENR2344 3412C EMCP II + For PEEC Engines Electrical System Schematic.
RENR2342 3412C EMCP II For PEEC Engines Electrical System Schematic.
2. Isolate Genset before commencing any work on the unit, activate emergency stop, open Genset breaker, and disconnect battery cables. Ensure health and safety requirements are adhered to at all times.
3. Install Load Sharing Module assembly Image 1.1.1
Image1.1.1
4. Clear generator area, reconnect batteries, release emergency stop, and clear emergency stop fault code.
5. Run functional test on Genset.
6. Put Genset package back into operations.