CYLINDER HEAD AS 3577398 - Caterpillar

the Engine Control Panel (ECP) requires additional information from the engine's Service Manual. The additional manuals that may be required are the Testing and Adjusting Section, "Schematics and Wiring Diagrams", and the Parts Manual for the engine that is being serviced.During troubleshooting, inspect all connections before any component is replaced. If these connections are not clean and tight, permanent electrical problems or intermittent electrical problems can result. Check that the wires are pushed into the connectors completely. Make sure that the connections are tight before other tests are made.Failure of an electrical component can cause the failure of other components. Also, failure of an electrical component can be caused by the failure of other components. Always attempt to correct the cause of an electrical system failure before you replace a component.Refer to Testing and Adjusting Section, "Schematics and Wiring Diagrams" when you troubleshoot the wiring. Perform continuity checks at the harness connectors in order to locate harness failures. At the connectors of the components, always check the ground circuit. Less than five ohms of resistance is required between the ground contacts of the connector and the frame ground. Excessive ground resistance that is greater than five ohms can cause incorrect diagnosing of problems.