CYLINDER & SEAL GP-BOOM 3585971 - Caterpillar

Illustration 8 g01300533
Remove bolts (12). Position clips (13) out of the way.
Illustration 9 g01300579
Illustration 10 g01300535
Remove bolts (14). Remove bolts (16). Pull back heat shield (15) and (17) .
Illustration 11 g01300536
Remove bolts (18). Remove combustion body group (ARD) (19) .Installation Procedure
Illustration 12 g01300536
Install combustion body group (ARD) (19). Install bolts (18) .
Illustration 13 g01300535
Illustration 14 g01300579
Position heat shield (17). Install bolts (16). Position heat shield (15). Install bolts (14) .
Illustration 15 g01300533
Position clips (13). Install bolts (12) .
Illustration 16 g01300584
Note: The clamp for the combustion body group (ARD) can be used only one time. Discard the clamp for the combustion body group (ARD) after use.
Install a new clamp (11) .
Illustration 17 g01300532
Connect tube assembly (10) .
Illustration 18 g01258629
Connect tube assembly (9). Install the gasket and connect tube assembly (7). Install bolts (8) .
Illustration 19 g01258627
Connect tube assemblies (6) .
Illustration 20 g01258625
Install bolts (5) .
Illustration 21 g01258624
Connect tube assembly (4) .
Illustration 22 g01258622
Connect ground wire (3). Install bolt (2). Connect coil wire (1) .
Turn the fuel supply to the ON position.End By: Install the clean gas induction cooler. Refer to Disassembly and Assembly, "Clean Gas Induction Cooler - Remove and Install".