CYLINDER GP-BUCKET 3588482 - Caterpillar

Illustration 1 g03235037
Right side view
Table 1
Specification for 393-4026 Hoe Stick Gp
Item Qty Part Number Specification Description
All bores must be free of paint. Coat all bores for the pins, bushings, bucket, and cylinder with 5P-0960 Grease Cartridge.
1 1 127-3913 Pin As Diameter is 59.86 0.03 mm (2.357 0.001 inch).
2 1 1R-6225 Pin As Diameter is 59.86 0.03 mm (2.357 0.001 inch).
3 2 166-1494 Lip Type Seal Lubricate the sealing lip of the lip type seals lightly with the lubricant that is being sealed. Install the dust seals so that the lip faces outside, as shown. Install the lip type seals so that the lip type seals do not extend beyond the face of the boss.
4 2 Bushing is one of the following part numbers:
357-5710 Bushing(1) Inside diameter before assembly is 80.36 0.03 mm (3.164 0.001 inch).
Installation depth is 9.5 0.8 mm (0.37 0.03 inch).
273-6814 Bushing(1) Inside diameter before assembly is 80.12 0.02 mm (3.154 0.001 inch).
Installation depth is 9.5 0.8 mm (0.37 0.03 inch).
240-2913 Bushing(1) Inside diameter before assembly is 80.20 0.04 mm (3.157 0.002 inch).
Installation depth is 9.5 0.8 mm (0.37 0.03 inch).
5 2 166-1492 Lip Type Seal Lubricate the sealing lip of the lip type seals lightly with the lubricant that is being sealed. Install the dust seals so that the lip faces outside, as shown. Install the lip type seals so that the lip type seals do not extend beyond the face of the boss.
6 2 248-7836 Lip Type Seal Lubricate the sealing lip of the lip type seals lightly with the lubricant that is being sealed. Install the dust seals so that the lip faces outside, as shown. Install the lip type seals so that the lip type seals do not extend beyond the face of the boss.
7 2 229-1095 Bushing(1) Inside diameter before assembly is 60.15 0.04 mm (2.368 0.002inch).
Installation depth is 9.5 0.8 mm (0.37 0.03 inch).
8 2 229-1091 Bushing(1) Inside diameter before assembly is 65.19 0.04 mm (2.567 0.002inch).
Installation depth is 9.5 0.8 mm (0.37 0.03 inch).
(1) Install the bushing in the bore so that the part number is facing outward.