CYLINDER BLOCK GP 3635760 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     4C-5593     Anti-Seize Compound     -    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01126410
Note: Install the connecting rod bearings dry when clearance checks are performed. Refer to Disassembly and Assembly, "Bearing Clearance - Check". Apply clean engine oil on the connecting rod bearings for final assembly.
Install a new lower half of connecting rod bearing (4) in connecting rod bearing cap (2) .
Install a new upper half of connecting rod bearing (4) in connecting rod (3) .
Pull connecting rod (3) onto the crankshaft.
Lubricate the new connecting rod bolts with Tooling (A) .
Install connecting rod bearing cap (2) and bolts (1) . Ensure that the number on the side of connecting rod bearing cap (2) is on the same side as the number on connecting rod (3) .
Tighten bolts (1) to a torque of 70 5 N m (52 4 lb ft).
Place an index mark on each bolt. Tighten each bolt (1) for an additional 120 5 degrees (1/3 turn).End By: Install the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Install".